LED Side Mirror Turn Signal Lights, Sequential Toyota Tacoma, RAV4, Highlander

COMPATIBILITY

• Tacoma 2016-2023 (3rd Gen) 
• RAV4 XA50 2019-2022
• Highlander XU70 2020-2022

NOTE:

• These only work if you already have a side mirror blinker and are just wanting the Sequential feature. This WILL NOT WORK IF YOU DONT HAVE A BLINKER IN YOUR SIDE MIRROR. 
• Works just fine with Toyota BSM (Blind Spot Monitoring

ABOUT THIS ITEM

• High Quality side mirror is made from high quality plastic for anticorrosion.
• Premium side mirror is a perfect match with the original car, our lights give your beloved car a fashion style and you will get a proper fitting
• Easy to Install Plug and play design, no modification or trimming needed, no additional resistors or relay required.
• Package Dimensions: 9.5 x 7.4 x 3.4 inches
• Package Weight: 14 ounces

PACKAGE INCLUDES

• 2pcs Left & Right LED Side Mirror Turn Signal Light

INSTALLATION STEPS

1. Remove the mirror cover with trim tool which can release some of those tabs. (Note: Be sure that the cover doesn’t fall on your driveway and crack or chip the paint.)
2. Remove two screws with a Philips screwdriver to loosen the bracket, and keep the screwdrivers.
3. Unhook the wires from the little hook signified by the left arrow, and depress twp prongs signified by the right arrow to release the pin.
4. Pull the factory turn signals out and depress the connector tab to remove from the light.
5. Connect the new turn signals, slip it into the groove on the bottom of the mirror and install them as factory one. (Note: Mark on the new light “L” for left or driver’s side, “R” for right or passenger side)
6. Put the cover back and test your lights.